Help! I'm not getting into hot water
Printed From: Carpet Cleaning Forum
Category: Carpet Cleaners Discussion
Forum Name: Truck Mount Carpet Steam Cleaning Machines & Equipment
Forum Description: Discuss anything relating to truckmounts
URL: https://www.kleenkuip.com/forum/forum_posts.asp?TID=5486
Printed Date: 29/April/2024 at 5:34am
Software Version: Web Wiz Forums 12.06 - https://www.webwizforums.com
Topic: Help! I'm not getting into hot water
Posted By: midlo777
Subject: Help! I'm not getting into hot water
Date Posted: 25/November/2008 at 6:15pm
|
I just bought a Pro Chem Power Direct with 1900 hrs
My water is only 140 deg I tried bleeding the heat transfer and it made
no difference. Not sure if I did it correctly. Any suggestions appreciated
|
Replies:
Posted By: Just Ol' Willy
Date Posted: 25/November/2008 at 9:52pm
|
You could try descaling. Depends on the water in your area.
------------- 
|
Posted By: FreshAire
Date Posted: 25/November/2008 at 11:00pm
CHECK TO MAKE SURE YOUR HEAT BYPASS VALVE IS NOT LEAKING and now without capslock (oops)
|
Posted By: John L
Date Posted: 26/November/2008 at 12:43am
It could be something simple like what tool ya using for cleaning? Maybe your flow rate is too high! Engine rpm's running too low? Make sure your anti-freeze is not low.. This would cause inadequate heat transfer to the liquid heat exchangers.. Is there a dema solenoid on it? It could be stuck in dump mode or may be loose.. Malfunctioning thermostat? Recalibrate or replace.. Exhaust leak in one of the fittings? 
And what they said above!
|