Welcome to KleenKuip.com's Professional Carpet Cleaners Discussion Forum!

  
Carpet Cleaning Forum Homepage
Forum Home Forum Home > Carpet Cleaners Discussion > Truck Mount Carpet Steam Cleaning Machines & Equipment
  New Posts New Posts RSS Feed - Help!   I'm not getting into hot water
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


Commercial Floor Cleaning Machines

Help! I'm not getting into hot water

 Post Reply Post Reply
Author
Message
midlo777 View Drop Down
Newbie
Newbie


Joined: 29/October/2008
Status: Offline
Points: 22
Post Options Post Options   Thanks (0) Thanks(0)   Quote midlo777 Quote  Post ReplyReply Direct Link To This Post Topic: Help! I'm not getting into hot water
    Posted: 25/November/2008 at 6:15pm
I just bought a Pro Chem  Power Direct    with 1900 hrs
My water is only 140 deg   I tried bleeding the heat transfer and it made
no difference. Not sure if I did it correctly. Any suggestions appreciated
Back to Top
Sponsored Links


Back to Top
Just Ol' Willy View Drop Down
Senior Member
Senior Member


Joined: 20/April/2007
Status: Offline
Points: 147
Post Options Post Options   Thanks (0) Thanks(0)   Quote Just Ol' Willy Quote  Post ReplyReply Direct Link To This Post Posted: 25/November/2008 at 9:52pm
You could try descaling. Depends on the water in your area.
Back to Top
FreshAire View Drop Down
Journeyman
Journeyman
Avatar

Joined: 13/May/2008
Location: Perth W. Aust
Status: Offline
Points: 251
Post Options Post Options   Thanks (0) Thanks(0)   Quote FreshAire Quote  Post ReplyReply Direct Link To This Post Posted: 25/November/2008 at 11:00pm
CHECK TO MAKE SURE YOUR HEAT BYPASS VALVE IS NOT LEAKING and now without capslock (oops)Wink
Back to Top
John L View Drop Down
Carpet Cleaning Guru
Carpet Cleaning Guru


Joined: 29/November/2004
Location: I'm Right Here!
Status: Offline
Points: 4013
Post Options Post Options   Thanks (0) Thanks(0)   Quote John L Quote  Post ReplyReply Direct Link To This Post Posted: 26/November/2008 at 12:43am
It could be something simple like what tool ya using for cleaning? Maybe your flow rate is too high!  Engine rpm's running too low? Make sure your anti-freeze is not low.. This would cause inadequate heat transfer to the liquid heat exchangers.. Is there a dema solenoid on it? It could be stuck in dump mode or may be loose.. Malfunctioning thermostat? Recalibrate or replace.. Exhaust leak in one of the fittings? Shocked
 
And what they said above!


Edited by John L - 26/November/2008 at 12:47am
Back to Top
 Post Reply Post Reply

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 12.06
Copyright ©2001-2023 Web Wiz Ltd.

This page was generated in 0.281 seconds.