No heat with RX-20

I find it ironic that someone called Steamy is haveing trouble with heat?

Something wrong with your powermatic, these units are usually very good at heating water, no matter how much you are using. Kerosene burners can heat water as fast as you use it.

They are like an oil furnace. It could need a filter and burner tip change. It also may be burning a little rich. I think there is also a flow control that ignites the burner on demand when you use water check it also.

if you are not getting heat it means your jet filters are cloged clean them out and any filters to the rx .the way your system works you need a certain amount of water to triger your flow switch  nothing wrong with your powermatic  pm me if you need advice on the powermatic its the best machine if you can mantain it

This was really the first issue I have had with the powermatic and I seem to have resolved it. It is somewhat tempermental at times, but I keep up with the preventative maintenance. I love it for the heat because I do a lot of greasy restaurants. I can run the temp between 240-250f all night long with no problems, and I don't have to tell you what those temps do to dirt and grease!! The burner tip change seems to have worked because I'm getting insane heat with the RX-20 again.