Pre-Spray vs. Detergent in Tank |
Post Reply | Page 12> |
Author | |
Beatrice West
Newbie Joined: 18/August/2023 Status: Offline Points: 14 |
Post Options
Thanks(0)
Posted: 08/November/2023 at 1:25pm |
We prefer to prespray and then hot water extract. I don't like leaving soap residue in the carpet when using detergent in the tank method. But, it also depends on what cleaning solution you are using.
|
|
Beatrice West Cleans the Best!
|
|
Sponsored Links | |
FuzzSucker
Senior Member Joined: 02/February/2008 Location: Lost and Found Status: Offline Points: 206 |
Post Options
Thanks(0)
|
i switched to pro-max for my emulsifier and it still leaves the carpet soft and I never have browning. I meter it according to the job difficulty and have been very pleased ever since. A little pricey, but a great product.
|
|
STEAM KING
Groupie Joined: 03/July/2006 Location: United States Status: Offline Points: 56 |
Post Options
Thanks(0)
|
I always pre-spray my carpets with my Hydro-Force and use detergent in my tank if the carpet is very bad otherwise no, just water. |
|
prouddadx3
Groupie Joined: 06/November/2008 Location: Boulder Status: Offline Points: 86 |
Post Options
Thanks(0)
|
I use my Hydro Force and pre spray all the carpet. If you heat your pre spray it makes the soap molecules more active. Their used to be a rule of 18. Once you hit 118 degrees the ability of the soap to cleans doubles for every 18 degrees hotter.If you use a slightly acidic water rinse it will leave the carpets softer and keep you from having PH browning. It was a long time ago when I heard that, probably twenty years or so.
http://www.colorado-carpet-masters.com/carpetcleaningBoulder.htm |
|
77748
Journeyman Joined: 12/August/2004 Status: Offline Points: 298 |
Post Options
Thanks(0)
|
Pretty much everything runs from the Hydroforce. The machine itself should get less wear and tear.
Commercial different ballgame you need it all. Olefin prespray, etreme, and solution SCR crystalization rinse. |
|
77748
Journeyman Joined: 12/August/2004 Status: Offline Points: 298 |
Post Options
Thanks(0)
|
Wow ! We hydroforce using Energiser, Attack or Enzal w/deoderizer then rinse with Performance CBS.
After reading this might start using just water to rinse. Curious how much money we would save in the course of lets say one month. If you think about it I am sure it has happened to everyone here where you forgot to turn the chemical back on after the prespray and was still impressed by your performance. Edited by 77748 - 13/November/2008 at 2:00am |
|
duckcountry
Master Carpet Cleaner Joined: 29/October/2005 Location: USA Status: Offline Points: 1082 |
Post Options
Thanks(0)
|
I prespray then shampoo. That does a great job cleaning the carpet for me. I then use fiber rinse in the extractor and use it as a rinsing machine/wetdry vac. Carpets come out clean and soft.
|
|
Are you in a high paying business or are you just a self employed low paid grunt who thinks this business provides dignity?
|
|
vernonpurcell
Newbie Joined: 22/May/2008 Location: Minnesota Status: Offline Points: 9 |
Post Options
Thanks(0)
|
You have to rember that a chemical injection sprayer will not syphon with tempratures over 60 c
Spraymasters are the best sprayes if you get the adjustable one
|
|
Thang
Senior Member Joined: 31/March/2007 Location: United States Status: Offline Points: 195 |
Post Options
Thanks(0)
|
Prespray all rooms and rinse with emulsifier.
|
|
Tap Out Or Pass Out!!!
|
|
CCandmore
Senior Member Joined: 07/December/2006 Location: Virginia, USA Status: Offline Points: 150 |
Post Options
Thanks(0)
|
Presray the entire room.
commercial - I use a Hydroforce sprayer with hot prespray. residential - good pump-up sprayer with hot prespray. If it is a large open area, then I use the Hydroforce. I rinse commercial with 9.5 ph mix, then fabset. I rinse residential with emulsifier/low ph rinse to bring carpet to neutral ph. If the carpet is berber or conditions won't allow it to dry fast enough, I fab set. Edited by CCandmore - 18/October/2007 at 7:18am |
|
STEAMPRO
Journeyman Joined: 11/October/2007 Location: United States Status: Offline Points: 319 |
Post Options
Thanks(0)
|
NO PRE SPRAY, JUST COLD WATER WITH A LITTLE BIT OF DISHSOAP, AND 80$ SCOTCH GUARD WHEN FINISHED! THUG LIFE!
|
|
Dennis Conner
SGK Basher Joined: 11/October/2004 Status: Offline Points: 640 |
Post Options
Thanks(0)
|
Look at kennibois van and you will see that he doesn't work much!
|
|
Steaminpile
Master Carpet Cleaner Joined: 04/February/2004 Location: Canada Status: Offline Points: 1155 |
Post Options
Thanks(0)
|
lately I've been using alot of good ol water for rinsing
doesn't tend to get that "brightness" that emulsifiers leave behind but carpets are much softer and less likely to resoil
If it's nasty I'll also use an emulsifier though the one I use is neutral ph |
|
A.K.A.
Andy |
|
Superglide Ken
Grand Potentate SGK Joined: 17/March/2004 Location: Canada Status: Offline Points: 4868 |
Post Options
Thanks(0)
|
I prespray and rinse all carpets, but only use emusifier in the rinse for the bad ones.Acid rinse the rest.
|
|
Inventor of the Teflon Wand Glide and the Turboteck Rotary Air Duct Cleaners for TMs.
|
|
Post Reply | Page 12> |
Tweet |
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Welcome to KleenKuip.com's Professional Carpet Cleaners Discussion Forum!